· · 3 min read
Wood Chipper for Demolition Wood Setup Guide
A wood chipper for demolition wood setup guide helps C&D recyclers process construction and demolition wood into boiler fuel, mulch and engineered products. Demolition wood is the riskiest feedstock: it carries nails, concrete, wire and sometimes treated or painted material that cannot go to certain markets. WeiDong Machinery builds demolition-rated chippers, and this guide covers metal removal, hazardous screening, machine settings and the daily safety routine.
Key Takeaways
- Remove nails, concrete and wire before feeding; use two magnet stages.
- Screen out painted or treated wood if the product market forbids it.
- Use a 2 to 3 inch screen for boiler fuel and 3 inch for erosion blanket.
- Plan 20 to 35 percent downtime on C&D feed for sorting and jams.
- Keep the rotor guarded; demolition feed throws projectiles.
Feed Screening and Prep
Inspect each load before it reaches the chipper. Pull metal, concrete chunks and hazardous material. Run a tipped load pass, then a magnetic separator on the conveyor. Treated wood, painted wood and composites should be separated if the fuel or mulch contract excludes them. Cut long framing into feed length and remove drywall screws from studs when practical.
| Contaminant | Action |
|---|---|
| Nails and screws | Magnet stages plus visual pass |
| Concrete and brick | Manual removal before feed |
| Treated or painted wood | Separate for approved disposal |
| Wire and cable | Cut out and remove |
Machine Setup
Set the bed knife gap at 0.090 to 0.120 inches to tolerate the abuse of C&D feed. Use hardened hammers or knives rated for demolition work. Use a 2 to 3 inch screen for boiler fuel and a 3 inch screen for erosion blanket; fine screens clog on demolition mix. Run the rotor at 1,000 to 1,300 rpm to reduce shock loading from embedded concrete.
Operational Workflow
Stage the operation so inspection happens at the dump point, before the feed pile. Keep a magnet ahead of the chipper and a second one after the screen if the product must be metal-free. Log rejected loads and knife hours. A clean workflow keeps the chipper running 65 to 80 percent of shift time.
Daily Safety Routine
Spend 20 minutes each morning checking tooling, screen, magnets and guards. Grease bearings and verify the emergency stop. Wear full PPE: demolition feed throws metal and concrete fragments. Keep a 40 foot clear radius and never clear a jam without lockout. At shift end, run clean wood through the unit and inspect the rotor.
Product and Compliance
Check the end-market rules before chipping: boiler fuel may reject treated wood; mulch contracts often demand metal-free and paint-free feed. Keep records of screening and tooling for audits. Erosion blanket and animal bedding products pay premiums for clean, screened material. Review the wood chipper product page for demolition-rated options before purchase.
Frequently Asked Questions
Can a chipper handle nails and concrete in demolition wood?
Only with two-stage metal removal and hardened tooling. Concrete must be pulled before feeding.
What screen should I use for C&D wood?
Use a 2 to 3 inch screen for boiler fuel and a 3 inch screen for erosion blanket.
How much downtime should I plan?
Plan 20 to 35 percent downtime for sorting and jam clearing on C&D feed.
Can treated wood go through the chipper?
Only if the end-market allows it. Many fuel and mulch contracts exclude treated or painted wood.
For budget planning, review the wood chipper vs wood shredder guide, check the current product range and contact WeiDong for a factory-direct quote.
Conclusion
A wood chipper for demolition wood stays safe and profitable when screening is the first production step. Pull the metal, guard the rotor and match the screen to the market. For a demolition-rated machine, contact the WeiDong sales team for a setup recommendation.