· · 2 min read

Straw Shredder for Bark And Slabs: Guide

Straw shredder for bark and slabs lets sawmills and panel plants convert bark and edgings into biomass, mulch or board material. Bark is abrasive and slabs mix wood with heavy bark, so the machine must be tough and the screen picked with care. This WeiDong guide covers real throughput of 6 to 14 tons per hour.

Key Takeaways

  • Real throughput: 6-14 t/h depending on moisture and mix.
  • Dry edgings: 12-14 t/h; wet bark: 4-6 t/h.
  • Use 40-80 mm screens for biomass and 25-50 mm for mulch.
  • Sand in bark wears hammers quickly.
  • Cost per ton: 2-5 euros in steady operation.

Why Recover Residues in the Sawmill

Waste disposal costs 30-80 euros per ton in some markets. An integrated straw shredder WeiDong converts bark and slabs into salable biomass, cutting landfill volume by up to 90%.

Throughput by Residue Type

MaterialPowerThroughputScreenUse
Dry edgings300-400 HP12-14 t/h60-80 mmBiomass
Wet bark350-450 HP4-6 t/h40-60 mmBiomass, mulch
Saw dust and bark mix250-350 HP6-8 t/h40-60 mmBoards, energy

Specific Configuration

  • Select a 25-80 mm screen according to the buyer.
  • Use a 900-1,200 rpm impact-resistant rotor.
  • Reverse hammers in wear-resistant steel.
  • Fit double magnets at the discharge for nails.
  • Clean the chamber every 100-200 hours.

Abrasion and Maintenance

Sand trapped in bark is the biggest enemy: it can shorten hammer life by 40% when uncontrolled. A magnetic separator and pre-cleaning reduce wear. With scheduled maintenance every 200-300 hours, the cost per ton stays low.

Economic Value of the Residue

Bark and slab chips feed boilers and pellet plants, while mulch sells for 10-60 euros per cubic meter at garden centers. This model follows the most profitable sawmill residue management practices in the forestry industry.

For line design, contact the WeiDong team via the contact form.

FAQ

Can bark heavily loaded with sand be shredded?

Yes, but pre-clean or brush it first; sand multiplies wear and lowers the value of the end product.

What screen works for boiler biomass?

40-80 mm gives good combustion; fractions below 25 mm raise the plant's energy cost.

How is material fed into the shredder?

Use a hydraulic feed roller and a straight infeed table so slabs align with the rotor and stay steady during chipping.

Keep reading